Interlux Pre-Kote primer is recommended to be applied anywhere above the true waterline. Interlux Brightside Polyurethane. Interlux Brightside rolls and tips great. I think the brand of paint has a lot to do with it too. Try to keep a wet edge, only roll about 4-5 feet at most then go back and tip it right away. Starting at $17.96. 1946 Chris Craft Brightside U22 Bottom Planking Update 6 ... How to easily roll and tip topside paint on your boat - Duration: 6:25. I would wait 24 hrs between coats. I have rolled and tipped with Awl-Grip. Good spraying equipment and technique will provide best result, but quite nice results can be gotten by the 'roll and tip… Interlux is a great paint. Probably added3 pounds to each hull but took out bad glass. I found I had to use a palm sander to knock down the PrimeKote and get a smooth finish. . One of the center boards were rubbed down about 5 inches from dragging on payment guessing. Use the largest brush possible. An uncomplicated alternative to two-part paints, Brightside® is a hard, high-gloss, one-part polyurethane topside finish with excellent abrasion and chemical resistance. It can be used anywhere above the true waterline, it’s easy to clean, resists staining and has great abrasion resistance. Read more. Degradable biocides Biocides are chemical ingredients in paint that inhibit the settlement and growth of organisms such as weed and barnacles on the bottom of a boat. Just hope this thing floats! Fluid_Ounces: Amazon.sg: Automotive At Interlux, we recognize the importance of providing high-quality technical support and advice to all our customers. CONTACT 159 West Main Street, Patchogue, New York 11772 +1-866-422-6348 info@boatbandit.com Dip the brush in appropriate thinner and then wipe off brush with lint free cloth if this starts to occur. I just did the work boat with a single part polyurethane, Interlux Brightsides. // ]]> -->, I have already primed one hull using preckote. Get the look of a two-part polyurethane with the application ease of a standard enamel. Create a pro-like finish with this long-lasting, high-gloss topside paint. On my trampoline I am doing a polypropylene in 4 inch strips and doing a basket weave. Remove sanding residue with a rag dampened with Brushing Liquid 333. ... Weld Mount Mixing Tips. My finish is/was indistinguishable from sprayed Awlgrip. It actually took about 3 weeks to fully cure. Don't let the paint dry on your tipping brush. Try to do the bottom first and then each side separately. Interlux is a great paint. It's a great forum with good folks. I'm a fan. The roller is used to apply paint to the surface and the pad or brush is used to create a smooth surface by ‘tipping off’. Tom I now understand you techniques and I will try to use it. Yes, and mn3 sent a video of a pro doing it. This results in any brush marks being able to flow out to give the best possible finish. We just kept rolling over the area until it looked good. I applied 3 coats, but could have stopped after the second. It should be used prior to painting to prepare your fiberglass, wood, or previously painted surfaces for paint application. I'm not expecting it to be perfect but you guys make it sound like it's going to suck total ass the minute it gets exposed to sunlight. Re: Roll and tip painting method ? I can buy this material from a supplier. RE: Thinning Interlux Brightsides Paint. If it has been painted and you don't know what's on it already, use a single part like EasyPoxy. Taylor Made Jaw Slides. I should've started a thread using the roll and tip method. roll and tip. Interlux and the environment: We have many products and systems designed to help you reduce your boating environmental footprint.